IQEDGE
RollCall Control Panel
Issue 1 Rev 1
Page 28
© 2017 SAM
5.9 Ethernet 1-3
The
Ethernet
pages show details and status for each network interface. The module defaults
to use of DHCP, but this can be overridden and a static IP address defined if required.
5.9.1 The Ethernet Pane
The
Ethernet
pane displays details of the currently selected network interface, and allows a
static IP address to be defined. Enter information as required, then click
S
to save. New
settings are applied when
Restart
is clicked.
The following options are also available:
5.9.2 The All Traffic/CPU Traffic Panes
The
All Traffic and CPU Traffic
panes display network traffic information; click the
Enable
Stats
check box to activate.
Figure 13 Ethernet N Page
Option
Operation
Where Am I
Causes card-edge LEDs to flash in the EDGE unit, allowing
it to be located visually. Click to enable.
Clear Link Change Count
Click to reset the Link Change counter to zero.
