Snap-on Equipment Hofmann ALIGNMENT FPA18210, Инструкция по установке и эксплуатации

Страница: 38 / 75

38 of 75
4. Ensure the proper operation of the approach ramps.
5. Cycle the lift serveral times to check proper operation of the cables, safety locks, air
locks, etc. with and without load.
STOP IMMEDIATELY IF THE LIFT IS NOT OPERATING PROPERLY!
6. Make any necessary adjustments and check again for proper operation.
NOTE: IF THE LIFT IS EQUIPPED WITH JACKING BEAMS, THIS IS THE
APPROPRIATE TIME TO INSTALL THEM. CONSULT THE JACKING BEAM
INSTRUCTION MANUALS FOUND IN EACH JACKING BEAM BOX.
Before attempting to operate the lift, please ensure that slider guide
surfaces inside the front towers are greased adequately.
7.15 FINAL CHECK OF ASSEMBLED LIFT

Final dimension check after anchoring

Check for air and hydraulic leaks

Ensure cables are properly routed and free from obstructions

Ensure all safety lock mechanism are working correctly

Re-check level of post and decks

Makes sure ramps are secured correctly with cotter pins and washers

Check all fasteners, tighten if necessary

Check direction of flow control (arrow pointed toward power unit).

If jack beams are supplied, ensure keeper bracket are installed

Check jam nuts on cables and safety ladders are tightened

Ensure cable flange clamp at cylinder is installed correctly and tighten

Ensure cylinder shaft Jam Nuts are installed as per instructions

Ensure wheelstops are installed

Ensure wheel chocks are provided

Operate lift to full stroke then lower to ground while checking for proper
functionality

Ensure Customer Care Kit is complete and given to operator

Operation Manual

ANSI / ALI Lift It Right Manual

ANSI / ALI Safety Tip Card

ANSI / ALI ALIS Safety Requirements for Installation and Service of
Automotive Lifts

ANSI / ALI Quick Reference Guide

Train end user on operation of the lift

Check level of hydraulic oil when the lift is fully lowered

Check the movement of the wire ropes through the entire travel of the lift.
Inspect for any binding or incorrect installation. Pay close attention to