Snap-on Equipment Hofmann ALIGNMENT FPA18210, Инструкция по установке и эксплуатации

Страница: 50 / 75

50 of 75
NOTE: The 3/4”

5½” lg. wedge anchor bolts supplied must have
a minimum embedment of 3¼” into concrete floor.
NOTE: If anchors do not tighten to required torque, OR project
more than 1½” above the concrete surface due to floor slope,
contact a foundation engineer to determine the best course of
ti
10.11 RUNWAYS
10.11.1 Check Runways

Check level of runways on the floor, on the locks and on the cables: Refer to
Section 6.10 . Adjust as required.

Check runways for damage or abnormal deformation. If such conditions exist,
contact Snap-on Equipment Technical Support.
10.11.2 Inspect Jackbeam Tracks

Inspect rolling jack / oil drain pan tracks for cleanliness, corrosion, excessive
wear or damage.

Clean dirty tracks.

Worn or damaged tracks should be repaired immediately.
10.12 COLUMNS
10.12.1 Check Columns

Check columns for corrosion, giving special attention to the area at the base of
the column.

Check severely corroded areas by pecking with an awl or welder’s chipping
hammer.

If column is corroded through at any point, it must be replaced immediately.

If not corroded through, remove old paint and rust scale, then coat with a high
quality corrosion resistant paint. Clean and lubricate glide blocks.
10.12.2 Check Column Anchors

Check column anchor bolts for tightness (if loose, re-torque to 110 ft-lb). If
anchors do not tighten to required torque, or continue to loosen, contact Snap-on
Equipment Technical Support.

Verify proper embedment of anchors after tightening.
10.13 APPROACH RAMPS, CHOCKS, FRONT WHEEL STOPS

Inspect for excessive wear or damage. Repair or replace if required.

Inspect hinge pins. Replace if excessively worn. Lubricate if in good condition