Snap-on Equipment Hofmann ALIGNMENT FPA18210, Инструкция по установке и эксплуатации

Страница: 10 / 75

10 of 75
3.1 SERVICE & ALIGNMENT WHEELBASE SPECIFICATION
4.0 INSTALLATION REQUIREMENTS & TOOLS
4.1 FOUNDATION
It is the user’s responsibility to provide a satisfactory installation area for the lift. Lifts
should only be installed on level concrete floors with a minimum thickness of six inches
(6") or 152 mm. Concrete must have a minimum strength of 4000 psi or 28 MPa and
should be aged thirty (30) days prior to installation. Please consult with an architect,
contractor or engineer if doubt exists as to the strength and feasibility of the floor to
enable proper lift installation and operation.
A qualified person should be consulted to address seismic loads and other local or state
requirements.
It is the user’s responsibility to provide all wiring for electrical hook-up prior to
installation and to insure that the electrical installation conforms to local building codes.
Where required, it is the user’s responsibility to provide an electrical isolation switch
located in close proximity to the lift that will enable emergency stop capability and
isolate electrical power from the lift for any servicing requirements.
4.2 TOOLS

ROTARY HAMMER DRILL

3/4” CONCRETE DRILL BIT

SELF LEVELING LASER OR 4’ LEVEL

HAMMER (for anchor installation)

PRY BAR (for shim installation)

CHALK LINE (lift location)

TAPE MEASURE

ELECTRICAL TAPE