Smiths Kelvin Hughes Nucleus 3 5000 Series, Системный справочник

Страница: 260 / 510

13
When A or B display is selected the previous menu is
replaced with the following menu:
14
Set up both Transceivers A and B as for a single
Transceiver installation, refer to Paragraph 4.
NOTE:
If the Dual Interswitch box is selected and any pushbutton
pressed, then the menu reverts to that shown in Paragraph
11.
RADAR I/SWITCH UNIT
15
If RADAR I/SWITCH UNIT is selected, the above
menu is replaced with the following RIU Installation
screen:
RIU Sys tem Setup
16
To set up a system using RIUs; configure one display,
then configure each individual transmitter in turn, then
transmit all configuration data from the first display to all
other displays in the system.
17
Highlight the RIU TRANSCEIVER INFORMATION
box and a pop-down box appears as follows:
18 Select VIEW to display the RIU Transceiver
Installation Information screen, as shown below.
19
This screen shows the configuration of Transceivers
used with the RIU.
NOTE:
Up to 6 transceivers and 6 displays can be connected via an
RIU. Transceivers not installed are labelled as NOT INST
and are identified by a red border.
20
Highlighting the transceiver causes a pop-up box to
appear indicating the selection options available. The
transceiver can be configured for X band, S band or as
Uninstalled. Turn AIS processing ON if scanner position is
near enough to ownship's GPS position, otherwise turn AIS
OFF.
21 For each installed transceiver the SKEW and MUTE
facilities can be set and the associated display can be
selected as Fitted or None, as shown below. (Refer to
paragraph 4). Turn AIS processing ON if scanner position is
near enough to vessel's GPS position, otherwise turn off.
Amdt. 5 5.3 July 03
KH 2020
Chap 5
CD-4792
View Other View
CD-4658
CD-4793
CD-4795
CD-4796
CD-4791