Smiths Medical 1818R, Руководство по эксплуатации и обслуживанию

Страница: 13 / 59

Chapter 1: Introduction
1-6 Oximeter Operation and Service Manual
2
WARNING! IEC 950 approved equipment must be placed
outside of the “patient environment.” The patient environ-
ment is defined as an area 1.5 m (4.92 feet) from the
patient.
2
WARNING! When attaching sensors with Microfoam®
1
tape, do not stretch the tape or attach the tape too tightly.
Tape applied too tightly may cause inaccurate readings
and blisters on the patient’s skin (lack of skin respiration,
not heat, causes the blisters).
CAUTION! Observe proper battery polarity (direction)
when replacing batteries.
CAUTION! Do not autoclave, ethylene oxide sterilize, or
immerse the sensors in liquid. Evidence that liquid has
been allowed to enter the monitor voids the warranty.
CAUTION! This device is intended for use by persons
trained in professional health care. The operator must be
thoroughly familiar with the information in this manual
before using the device. (Notice: This device is not
approved for home use by a non-health care profes-
sional.)
CAUTION! Connect only the printer adapter specifically
intended for use with this device (see Optional Supplies
and Accessories).
NOTE! Operation of this device may be adversely affected
in the presence of strong electromagnetic sources, such
as electrosurgery equipment.
1. Microfoam is a registered trademark of the 3M Company.
Figure 1-1: Patient Environment