9
Photo 17
12
11
Step 8:
OPTION 1: This is only for stations with
the solenoid valve mounted to the control
panel and with a delay timer on the
solenoid valve.
Connect the DIN connector
(Item 9)
to
the solenoid valve on the dome assembly
(Item 1)
and tighten the connection screw
with a screw driver
(see Photo 15)
. Run
the DIN connector cable
(Item 9)
back to
the control panel.
Run the cable along the motor conduit
cable and fasten it to the motor conduit
with cable ties
(Item 10) (see Photo 16)
.
If a higher enclosure rating must be
maintained or if you want a separate cord
grip for the
DIN connector cable (item 9)
,
put a 3/4” hole in the control panel to install
the
cord grip (item 11)
. Place the
o-ring
(item 12)
for the
cord grip (item 11)
onto
the cord grip body
(item 11)(see photo
17)
and run it up against the shoulder of
the cord grip.
OR
The
DIN connector cable (item 9)
can be
run through an existing panel hole if the
enclosure is NEMA 1 rated. If you elect
to do it this way, a new hole in the control
panel does not need to be drilled.
Photo 15
1
9
Photo 16
9
10
