12
Run the cable along the motor conduit and
fasten it to the motor conduit with cable
ties
(Item 10) (see Photo 25)
.
If a higher enclosure rating must be
maintained or if you want a separate cord
grip for the
DIN connector cable (item 9)
,
put a 3/4” hole in the control panel to install
the
cord grip (item 11)
. Place the
o-ring
(item 12)
for the
cord grip (item 11)
onto
the cord grip body
(item 5)(see photo 26)
and run it up against the shoulder of the
cord grip.
OR
The
DIN connector cable (item 9)
can be
run through an existing panel hole if the
enclosure is NEMA 1 rated. If you elect
to do it this way, a new hole in the control
panel does not need to be drilled.
Use the cord grip nut
(item 13)
to hold the
cord grip
(item 11)
in place
(see Photo
27)
. Run the DIN connector cable
(item 9)
through the cord grip
(item 11)
or existing
panel hole and tighten the cord grip
(item
11)
to secure the DIN connector cable
(item 9)
.
To install the new delay timer
(Item 14)
to
the back of the control panel, find a spot in
the panel to mount the delay timer
(Item
14)(see Photo 28)
.
Photo 28
14
Photo 27
13
11
Photo 26
12
11
Photo 25
9
10
