11
Diagram 4
shows the updated typical
schematic after changes have been made.
Remove the old solenoid valve completely.
It is recommended that the hole is plugged
to protect the control panel (plug not
provided)
(see Photo 22)
.
Make sure any loose wires have a wire nut
installed to the end and that all neutral and
ground wires are still tied together properly
(see Photo 23)
.
Go to step 11.
Photo 22
Photo 23
Diagram 4 - Option 1 - After
Step 9:
OPTION 2:This is only for stations with
the solenoid valve mounted to the control
panel and no delay timer on the solenoid
valve.
Connect the DIN connector
(Item 9)
to
the solenoid valve on the dome assembly
(Item 1)
and tighten the connecting screw
with a screw driver
(see Photo 24)
. Run
the DIN connector cable
(Item 9)
back to
the control panel.
Photo 24
1
9
