WD1050
12/04/2010
Pag. 13
5.6. WATER
DRAIN
CONNECTION
This machine has just one outlet hose.
The internal diameter of the hose is ½” so it can be connected to any standard ½”
hose adapter.
General rules for installing outlet
The washing water outlet hose must be placed with its curved section hooked onto the
edge of a sink or waste pipe. A drain pipe with siphon should be used.
The following precautions should be observed during installation:
•
As the water drain temperature may reach about 93°C the end of the outlet hose
must be connected firmly to the drain by using clamps.
•
The outlet hose must not have any tight bends liable to obstruct the flow;
•
The end of the outlet hose must not be placed either more than 80cm or less than
65 cm above the surface on which the machine is installed;
•
The end of the hose must under no circumstances be immersed in water;
•
The internal diameter of the waste pipe must be at least Ø 40 mm;
•
We recommend installing a waste pipe of diameter 50 mm;
•
Don't use waste pipe extensions.
fig. 4 – 65 cm < A < 80 cm
WARNING
The drain connection must comply with international standards.
Our company will accept no liability for pollution caused by the
machine.
.
