The first line of display shows the DTC “P” code. The second line shows the DTC code description.
If the DTC code description is longer that the physical dimension of the display, the description will
scroll across the screen.
Clearing DTC codes
At the end of the DTC code list, Smarty can either clear all the stored DTC codes from the ECM
memory or exit:
Press the ‘1’ key, to clear all the DTC codes stored in the ECM.
Press the ‘2‘ key, the DTC codes will not be erased and Smarty will return to the main screen.
When the erasing operation has been completed, the following screen appears:
8. ABS Update
(tire height update)
Once Smarty is VIN# Locked (i.e. a CaTCHER software has been loaded in the ECM) the
speedometer of the vehicle can be adjusted according to the tire height.
From the main menu, shown below, press the ‘1’ key.
To change the tire height, choose the ABS update function:
Press the ‘2’ key, in the second menu as shown below:
Smarty will try to establish the communication with the ABS.
If the ignition key was not turned to the “RUN” position Smarty will display this message:
Press the ‘>’ key, then Smarty will prompt you to turn on the ignition key to retry the connection:
When the connection has been established, Smarty shows the current tire height (Curr Tire:) in the top
line of the screen:
Type in the correct tire height with the numerical keys, entering a decimal point is not required.
Any tire height from 25.00” to 45.00” can be chosen in 0.05” increments. If you enter an increment
other than 0.05”, Smarty will round it to the next correct increment. The ‘<’ key can be used to
change entries.
After you have entered the correct tire height, press the ‘>’ key. Smarty will prompt you for
confirmation to proceed:
The ‘<’ key can be used return to the previous screen to change the New Tire size.
Page 13 of 16
