Changing Software
Turn on the ignition key to the RUN position. DO NOT START THE ENGINE.
Plug Smarty’s cable into the diagnostic connector of your vehicle. Smarty will display:
When the “ # “ symbols are displayed on the first line, Smarty is VIN# locked to a vehicle.
The second line of the display shows the firmware version and the tuning data version.
After a few seconds the PoD menu will appear:
Press the ‘2’ key to select the main menu:
Press the ‘1’ key, and Smarty displays the following screen:
Press the ‘1’ key to select ECM Update. Smarty asks you to select either CaTCHER Software
Versions (see Change CaTCHER Programs below) or the STOCK software:
Return to STOCK program
Press the ‘2’ key. Smarty asks for confirmation to restore the ECM to STOCK software:
Press the ‘>’ key. The ECM is restored to STOCK software and Smarty is unlocked. Smarty can now
be used on another vehicle.
Change CaTCHER parameters
Press the ‘1’ key in the above described menu. Before the programming, The optional parameters
have to be adjusted. The list of optional parameter varies according to the installed software. Please
see the previous chapter for the parameter description. A the end of the parameters adjustment, Smarty
asks the confirmation to program the ECM:
Press the ‘>’ key to confirm your selection and to begin the updating session. You will see the
following screen:
Smarty checks its memory content before sending the data to the truck.
After a few seconds, a numeric counter begins with the percentage of the transmitted software. At the
end of transmission (when 100% is reached), Smarty will update the functional parameters of the
ECM. The following screen will appear:
Page 9 of 16
