SmartSight S1600e, Руководство пользователя

Страница: 25 / 113

User Manual Configuring the Unit
11
16
Configure the serial port parameters to match those of
the target equipment (for instance, camera or PTZ
keyboard).
For more information, refer to the SConfigurator User
Manual.
The S1600e initial configuration is now complete. You
perform further configuration with SConfigurator.
Performing a Point-to-Point
Connection
To allow transfer of video, audio, I/O, and serial data, you
have to create a connection between a transmitter and a
receiver. Typically, both units sit on the same IP subnet as
SConfigurator and have the same VSIP port; to access other
units, refer to the unit discovery section in the SConfigurator
User Manual.
For more information about the connection process, refer to
the “Managing Connections” chapter, also in the
SConfigurator User Manual.
To perform a point-to-point connection:
1
Start SConfigurator.
2
In the Units tab, discover the desired units.
The discovered units appear in the Units box.
Note
The two units must have the same firmware version, with the following
exception: The S1504e and S1508e, both at firmware release 3.0, will work
with an S1600e receiver at version 2.60.