Assembly & Operation Manual
TAIL PIPE
Dril holes in mounting lugs of tail pipe.
Make 90 degree bend in each mounting lug.
Slide tail pipe through nose into position. Note: The
rear of pipe must just exit the rear former by 10mm.
Mark location of screws on turbine rail.
Dril pilot holes for self tap screws.
Secure pipe in position and glue end of pipe with
silicon glue to former.
Glue bellmouth with silicon glue.
Photo 44
Photo 45
FUEL CELLS
NOTE: Later versions of F86 have different tank configura ons.
This due to fact that all fuel before CG.
Rinse 3 fuel tanks and check for leaks.
Make up 3 fuel line fittings. Make sure clunk moves
freely and reaches all corners of inside of tank.
Fit to tanks. Mark pipes for “inlet” and “outlet”.
Rough the outside of tanks. Use silicon glue and glue 3
tanks in position.
Install turbine mount.
Plumb tanks using diagram
on next page.
Fill tanks and check for leaks.
Drain tanks with fuel pump and check no air bubbles
in system until last drop is drained. A good plumbing
will secure good turbine operation.
P-19
Photo 46
Photo 47
Photo 48
