Draw line perpendicular across flap hinge line.
Cut hole in trailing edge of wing for flap pushrod.
Trial fit flap and mark loca on of horn on flap. (make
sure horn clear wing when flap in “up” posi on.
Remove flap and cut slot for horn. Glue horn with 30
minutes epoxy.
Refit flap and cut slot for pushrod into flap leading
edge. Check opera on of flap for full movement with-
out binding.
When happy glue flap hinges with 30 minute epoxy.
Tape flap in “up” posi on while glue cure.
Take care not to get
any glue between wing and
flap. Wipe off all access glue.
Draw line perpendicular across aileron hinge line.
Mark loca on for pushrod and horn.
Carefully bend aileron open.
Cut
slot for aileron horn.
Cut hole for aileron pushrod.
Glue aileron horn in posi on.
Insert pushrod and insert safety clips.
Check that aileron operate freely.
Secure servo covers for flaps and ailerons.
Repeat for other wing.
Cut round hole in root just to the back of main
spar. This hole for servo wires and air pipe.
Trial fit wings to fuselage and mark loca on of hole for servo wires.
Cut hole in fuselage.
P-14
Assembly & Operation Manual
Photo 23
Photo 24
Photo 25
Photo 26
