Assembly & Operation Manual
STABILIZERS
NOTE:
Make sure to have some sort of protective foam on the work bench. This will
protect the paint surface from unwanted dents. Assemble both stabilizers simultane-
ously. All linkages are hidden. If you have a transport problem it maybe necessary to
remove stabilizers for transportation. If not then simply glue stabilizers to fuselage.
Mark √ each step.
Locate all parts for this section
Fit elevator to stabilizer and mark hinge line.
Cut slot in elevator for pin hinges. (Hinges pivot point
inside elevator)
Glue 3 pin hinges and secure to stabilizer. Take car
not to get glue on hinge point.
Locate 2 carbon tubes of equal length.
Make up pushrod of equal length.
Insert wire belcrank into belcrank pipes.
Mark location of belcrank in wire.
Remove and cut 3 flat slots into wire. (Note–
Belcrank must be fitted as close to side of fuse-
lage. The wire must not be able to move side-
ways.
Secure belcrank to wire by means of 3 cap
crews. Use loctide.
P-15
Photo 27
Photo 28
Photo 29
Photo 30
Photo 31
Photo 32
