Assembly & Operation Manual
CONTROL LINKAGES
Flaps : 80mm (2)
Aileron : 75mm (2)
Slats : 75mm (4)
Elevator : 500mm (2)
Rudder : 230mm
Steering: 50mm
WINGS
NOTE:
Make sure to have some sort of protective
foam on the work bench. This will protect the paint
surface from unwanted dents. Assemble both
wings simultaneously. Mark √ each step.
Check operation of Landing gear and doors.
Remove factory self tapping screws and re-
place with high quality screws.
Inspect landing gear blocks. Make sure all
parts are glued.
Fit quick disconnects to air line.
Tighten brake drum.
Check the operation of brake
Remove flaps and slats from wing panel.
Remove and mark servo covers and inspect
plywood. Use dremel to clean out some glue
and ply to make sure servos will fit well.
P-12
Photo 15
Photo 16
Photo 17
