Fit 2 L-shape servo brackets to 2 x JR DS8511
(flap + aileron) and 2 x JR DS8401 (slats) servos.
All servos must be mounted with horns facing
down. For the flaps and slats the horn must be
closest to control surface and furthest away for
aileron.
Secure servo horns and centre servo’s with TX.
Secure 4 x extension wires. Use safety clips on joint.
Secure servo’s to wing. Use 4 servo screws.
Draw a line perpendicu-
lar to hinge line.
Mark off area for slat pushrod as indicted in photo 20.
Use file or dremel to open up hole. Repeat for other
slat servo.
Mark loca on of horns on slats.
Use Dremel to cut slot for control horns.
Use 30 minute epoxy to glue control horns
A er epoxy cured, insert pushrods and secure safety
clips.
Check opera on of slats.
Secure servo covers with
4
x 1mm set screws.
P-13
Assembly & Operation Manual
Photo 18
Photo 19
Photo 20
Photo 21
Photo 22
