SkyAzúl Greer MG514, Инструкция по установке, калибровке и обслуживанию

Страница: 70 / 90

67
3.7.1 Checking the Reeling Drum Cable Layering
The reeling drum is designed to provide accurate measurement of boom extension. To provide
accurate measurement, the REELING DRUM CABLE must form a single flat layer across the surface of
the reeling drum as the boom is telescoped in and out. Any stacking of the cable will cause extension
errors as the boom retracts.
1. Telescope the boom fully out and then fully in.
2. Check that the reeling drum cable forms a flat single layer across the surface of the extension
reel, with each successive turn of cable laying next to the last.
NOTE: If any stacking or build-up of the cable occurs, ensure the first cable guide at the top of the
boom root section is correctly aligned with the outside edge of the extension reel. Clean the reel-off
cable, and lubricate it with a silicone spray, as shown in Figure 3.7.1 below.
FIGURE 3.7.1 - REELING DRUM VIEWED FROM ABOVE
SkyAzúl, Equipment Solutions www.skyazul.com 301-371-6126