SkyAzúl Greer MG514, Инструкция по установке, калибровке и обслуживанию

Страница: 31 / 90

28
2.6.7 Menu 06 - Pressure
This menu is used to determine the pressure of the boom hoist cylinder. A calibrated load is needed to
calculate the diameter of the boom hoist cylinder. Use a load approximately 80% of the single part load
rating. If a smaller weight is all that is available, extend and/or lower the boom to about 55° to induce
higher pressure in the base of the cylinder.
1. Press the Next or Prev button until “06 Pressure” appears in the information window at the right.
NOTE: Pressure cannot be calibrated until the L, J, G, and H dimensions have been calculated and
entered into the system.
2. Press the 06 Pressure button to enter the routine.
3. Enter the piston diameter. If not, press the Exit button.
4. Enter the rod diameter. If not, press the Exit button.
5. Press the Pressure Monitor button.
6. With the boom slightly raised, examine the piston and rod side pressures. The rod pressure
should be close to zero with the piston pressure indicating a higher value. When lowering the
boom, the base pressure should be close to zero with the rod pressure indicating a higher
value.
7. Press the Edit button if the Pressure Threshold or Rod Side Offset need to be adjusted.
TEST
SET
TEST
SET
TEST
SET
SkyAzúl, Equipment Solutions www.skyazul.com 301-371-6126