SkyAzúl Greer MG514, Инструкция по установке, калибровке и обслуживанию

Страница: 15 / 90

12
2.0 Calibration
2.1 Required Tools
•
1/4” nut driver or T15 Torx driver
•
Digital or bubble level calibrated and accurate to 0.1° at level
•
Digital volt/Ohm Meter capable of measurements to three decimal places
•
100 foot measuring tape: fiber type graduated in tenths of feet
NOTE: The computer calculates measurements in feet and tenths of a foot, so using the correct tape
measure is essential for entering the measurements.
2.2 Number Conversion
If a standard tape measure is being used, convert the measurement into feet and tenths of a foot. For
example: a distance of 35’–6” would be entered into the system as 35.5 feet. Whole inches can be
easily converted by dividing by 12 (6/12=.5). Fractions of an inch are converted by dividing the
numerator by the denominator.
For example: 1/4 inches would be entered as .25 (1/4=.25). Conversion of whole inches and fractions
of an inch (for example 6-
1/4”) are converted by first converting the fraction to a decimal and then
dividing by 12. In this case 6- 1/4” is converted to 6.25 and then divided by 12 which equals 0.520. Refer
to the Fraction to Decimal Conversion Chart.
When entering weights, convert the number by moving the decimal three places to the left. For
example: enter 1,400 pounds as 1.4, enter 300 pounds as .300.
SkyAzúl, Equipment Solutions www.skyazul.com 301-371-6126