Skope 400 A, Инструкция по эксплуатации

Страница: 34 / 68

30
5. Remove the overflows installed inside the containers by the back of the machine. (See illustration: 1)
6. Once the containers are emptied, put the overflows back in.
7. If the containers and evaporators are completely clean, you should run two washing cycles with water only to
eliminate any remains of dirt left by the previous cycle.
CAUTION: ** DISCARD THE ICE PRODUCED IN THIS FIRST CYCLE.
8. Clean and assemble all the components, check that the grille is clean and that the cubes slide well. Check that
no slat is jammed in the curtain.
9. Check and/or change the water inlet filters.
10. Check that the injectors are in position. When necessary, disassemble, clean and put them in the correct
position.
8.4 COLLECTOR AND INJECTORS
1. Remove the curtain. 2. Remove the collectors from their axles by pulling gently upwards.
2. Remove the expulsion grille for fallen ice. (Clean it just like the curtain.)
3. Disassemble the injectors and clean them.
4. Disassemble and clean the main filter of the water pump. (It is pressure-assembled.)
5. Install filter, injectors and collectors.
CAUTION: IT IS VERY IMPORTANT WHEN YOU RE-INSTALL THE COLLECTOR THAT THE INJECTORS ARE
PUT BACK IN THE SAME POSITION.
1