Skope 400 A, Инструкция по эксплуатации

Страница: 18 / 68

14
4. START UP
4.1 PRIOR CHECK

Is the machine level?

Are the voltage and frequency as indicated on the plate?

Are the drains connected and do they work?

Is it connected to cold water?

** If the machine is air condensed, are the air circulation and the temperature of the premises right?
MAXIMUM MINIMUM
AMBIENT TEMP. 43ºC 5ºC
WATER 35ºC 5ºC

Is the water pressure correct?
MINIMUM 1 Bar / 0.1 MPa
MAXIMUM 6 Bar / 0.6 MPa
NOTE: If the incoming water pressure is greater than 6 Bar, install a pressure reducer.
CAUTION: CHECK THAT THE VOLTAGE AND FREQUENCY OF THE MAINS ARE THE SAME AS THOSE INDICATED ON
THE NAME PLATE.
4.2 START UP
After following the installation instructions (ventilation, conditions of the premises, temperatures, water quality,
etc.), proceed as follows:
1. Open the tap to let water flow. Check that there are no leaks.
2. Connect the machine to the mains with its corresponding protection.
3. Activate the button on the display installed on the front of the machine.
4. Check that there is no part which is rubbing or vibrating.
5. Check that the curtain can move freely.
6. Check that the injectors send the water to the evaporator in the correct direction.
7. Check that the collectors turn freely on their axles.
8. Once 10 minutes have passed, check that the water container has no leaks through the maximum level overflow
channel.
Note: The electronic plate has a battery to keep the date and time. The battery is protected with a plastic to
prevent their consumption. The first time using the unit, remove the plastic (opening the upper compartment,
display area, access to the electronic board box and inside is the battery with plastic).