Siqura PD900 Series, Руководство пользователя

Страница: 19 / 64

Web interface
Page 19
1
Run the SDM2 program.
2
After the SDM2 window has appeared, click the Edit and Manual Scan for Devices menu option to
manually search for the camera based on the IP address, if known. All the found IP devices will be listed on
the page automatically if the
Device auto detection is enabled.
3
Find the camera by looking for its IP address.
4
Double-click or right-click and select Open device web page to access the camera through the web
browser.
5
A prompt window requesting for a username and password will appear. Enter the username and the
password to log in on the camera (default login username: Admin, password: 1234).
Configure the camera Networks settings:
 IP address
This is necessary for network identification.

Subnet mask
This configures the address destination is in the same subnet. The default
value is “255.255.255.0”.

Default gateway
Denotes the gateway used to forward frames to destinations in a different subnet. An invalid gateway
setting will cause the transmission to destinations in a different subnet to fail.
 Primary DNS
Denotes the primary domain name server that translates hostnames into IP addresses.
 Secondary DNS
Denotes a secondary domain name server that backs
up the primary DNS.

Use PPPoE
For the PPPoE users, enter the PPPoE username and password in the relevant entry fields and click the
Save
button to complete the setting.
Advanced
Below follows a description of the camera’s Web Server port, RTSP port, MJPEG over HTTP port and HTTPS port.

Web Server port
The default web server port is 80. With the default web server port 80, you can simply enter the IP address of
the camera in the URL bar of a web browser to connect the camera. If the web server port is changed to a port
number other than 80, you have to enter the camera’s IP address followed by a colon and the port number. For
instance, a camera with IP address 192.168.0.100 and web server port 8080 can be connected by entering
http://192.168.0.100:8080 in the URL bar.

RTSP port
The default setting of RTSP port is 554. the RTSP port should be set to 554 or a value in the range of 1024 to
65535.

MJPEG over HTTP port
The default setting of MJPEG over HTTP port is 8008. The MJPEG over HTTP port should be set to 8008 or a
value in the range
of 1024 to 65535.

HTTPS port
The default setting of HTTPS port is 443. The HTTPS port should be set
to 443 or a value in the range of 1024 to
65535.
Note: Make sure the port numbers set above are not the same; otherwise a network conflict may occur.
IPv6 Address Configuration
If the network supports IPv6, you can activate the Enable IPv6 checkbox and click the Save button. An IPv6 address
will appear beside Address , and you can use it to connect to the camera.
3.2.3.2 QoS
QoS allows for providing differentiated service levels for different types of traffic packets, which guarantees delivery
of priority services, especially in the event of network congestion. By adapting the Differentiated Services (DiffServ)
model, traffic flows are classified and marked with DSCP (DiffServ Codepoint) values, and will receive the
corresponding forwarding treatment from DiffServ capable routers.