SIGMATEK DIAS-Drive 335-23, Руководство пользователя

Страница: 56 / 94

DIAS-DRIVE 335-23
Page 54 27.09.2017
9 Motor temperature Motor temperature switch is
triggered
Break in feedback cable or
connectors
Check cause (Motor under-
dimensioned; poor environmental
conditions)
Check feedback cable and connector,
exchange if necessary
10 Environmental
temperature Internal temperature too high improve ventilation in the cabinet and
check mounting position according to
this manual
11 Heat sink temperature Heat sink temperature too high Improve ventilation in the cabinet and
check mounting position according to
this manual
12 Feedback error Feedback cable broken
feedback device defective
Bad feedback connection
Check feedback cable and replace if
necessary
Replace feedback device
Check feedback connection
13 Commutation error Incorrect motor phase position
Wrong wiring of motor or
feedback cable
Check M-ROFF
Check motor connection
14 Motor over speed Incorrect motor phase position
Incorrect motor connection or
wrong feedback cable
Over shoot (greater than
1.2 * V-NMAX)
Check M-ROFF
Check motor connection
Check feedback cable
Optimize control loop
15 Drag error P-PEMAX lag window too small Increase P-PEMAX and/or optimize
control loops
16 Trajectory error The speed setting, which was
calculated using the change in
the position setting by the host, is
higher than 10000 r/min
-1
Check P-PSCALE and
P-SSCALE parameters and the
reference value of the controller
17 Host communication No new preset values were
transmitted for two successive
cycles
Internal communication error with
the interface
Synchronization is not engaged;
check
A-CTIME and the cycle time of
the control
Check A-STIME
Communication disrupted, check
see also
I-DERROR
18 Amplifier error E2
(I-DERROR) Various internal errors see also I-DERROR
Contact manufacturer