SIGMATEK DIAS-Drive 335-23, Руководство пользователя

Страница: 55 / 94

DIAS-DRIVE 335-23
27.09.2017 Page 53
5.2.3 Status Register
With I-STATUS , the status of the DIAS-Drive can be read. All error and status information is
contained in a 32-bit variable. The amplifier function can be changed by setting the
appropriate bits via using the
G-MASKE1 , G-MASKE2 , G-MASKW and G-MASKD
commands.
According to the mask settings the amplifier detects errors, warnings or does not respond.
The individual bits have different values and limitations in the mask assignment.
Bit Error Cause Solution
0 Single-phase
operation The main supply voltage is single
phase only Check the amplifier fuse
Check electrical connection
1 Error in the main
voltage supply Amplifier is "enabled" without the
applied main voltage supply check fuses in the mains supply
check electrical supply
Amplifier is enabled before the DC-link
voltage is loaded
2 reserved
3 DC over voltage Internal / External regen resistor
not connected
Internal regen resistor defective
External regen resistor defective
connect regen resistor
replace amplifier
replace external regen resistor
4 DC under voltage The main voltage supply for the
enabled amplifier is too low disable amplifier before the DC-link
voltage crosses the under-voltage
threshold set by
G-VBUSM
5 reserved
6 Holding brake error No holding brake connected with
parameter
M-BRAKE = 1
Short circuit in holding brake
cables
Short circuit in the holding brake
Use motor with holding brake
Check holding brake cable
Change M-BRAKE parameter to 0 as
long as a motor without brakes is used.
Check connector and motor cable
Check holding brake
7 Brake switch error Defective internal stop brake
switch
No holding brake connected in
parameters
M-BRAKE = 1
Replace amplifier
Use motor with holding brake
Change M-BRAKE parameter to 0 as
long as a motor without brakes is used.
Check connector and motor cable
Check holding brake
8 reserved