Programming and Operating Manual (Milling)
120
6FC5398-4DP10-0BA1, 01/2014
See the following sequence of the approach motion dependent on G340/G341 (example with G17):
Programming example: Approach along a semi-circle with infeed
N10 T1 D1 G17 G90 G94
; Activate tool, X/Y plane
N20 G0 X0 Y0 Z30
; Approach P0
N30 G41 G347 G340 DISCL=3 DISR=13 Z=0 F500
; Approach along a semi-circle with radius: 13 mm,
; Safety clearance to the plane: 3 mm
N40 G1 X40 Y-10
N50 G40 X20 Y20
N60 M30
alternatively N30/N40:
N30 G41 G347 G340 DISCL=3 DISR=13 X40 Y-10 Z0 F500
or
N30 G41 G347 G340 DISCL=3 DISR=13 F500
N40 G1 X40 Y-10 Z0
Explanation with regard to N30/N40:
By using G0 (from N20), the point P1 (starting point of the semi-circle, corrected by the tool radius) is approached in the
plane Z=30, then lowering to the depth (P2, P3) with Z=3 (DISCL). The contour is reached at point X40 Y-10 in the depth
Z=0 (P4) along a helix curve at a feedrate of 500 mm/min.
Approach and retraction velocities
●
Velocity of the previous block (e.g. G0):
All motions from P0 up to P2 are executed at this speed, i.e. the motion parallel to the machining plane and the part of
the infeed motion up to the safety clearance DISCL.
●
Programmed feedrate F:
This feedrate is active from P3 or P2 if FAD is not programmed. If no F word is programmed in the SAR block, the
velocity of the previous block will act.
●
Programming using FAD:
Specify the feedrate for
–
G341: Infeed motion vertically to the machining plane from P2 to P3
–
G340: from point P2 or P3 to P4
If FAD is not programmed, this part of the contour is traversed at the speed which is active modally from the
preceding block, in the event that no F command defining the speed is programmed in the SAR block.
