Siemens SIMOTRAS 6SG7050, Руководство по эксплуатации

Страница: 90 / 604

Start-up 01.04
7-4
SIEMENS AG 6SG7000-0BA76
SIMOTRAS HD Operating Instructions
LED displays
Run green LED
LED illuminated
⇒
in “Torque direction active” state (MI, MII, M0).
(see r000 in Section 11)
Ready yellow LED
LED illuminated
⇒
in “Ready” state (o1 .. o7).
(see r000 in Section 11)
Fault red LED
LED illuminated
⇒
in “Fault signal present” state (o11)
(see r000 in Section 11 and Faults and Alarms (Section 10))
LED flashing
⇒
An alarm is active (see Faults and Alarms in Section 10).
7.2.2 User-friendly operator control panel (OP1S)
The optional, user-friendly, operator control panel with plaintext display (order no.: 6SE7090-
0XX84-2FK0) is mounted in the special location provided in the converter door.
This location provides a connection to the serial basic converter interface SST1.
Parameters can be selected directly through input of the parameter number via the keyboard of the
OP1S. The following interrelationships apply:
Displayed
number
Number to be keyed in
on OP1S
r xxx, P xxx
(0)xxx
Basic converter
parameter
U xxx, n xxx 2 xxx
H xxx, d xxx 1 xxx
Technology board
parameter
L xxx, c xxx 3 xxx
If the UP or DOWN key on the OP1S is used to select adjacent parameter numbers, then any
missing numbers in the range of basic converter parameters are skipped.
This automatic skipping over missing numbers does not work for technology board parameters. In
this case, the numbers of existing parameters must be entered directly.
The OP1S switches to Operating display a few seconds
after initialization.
By pressing the <P> key, you can switch from the
operating display to the
Basic menu in which you can
either select "Free access" to all parameters or a variety of
functions. Details of these functions can be found in the
function diagram "OP1S operating display" (Section 8,
Sheet Z123) and the OP1S operating instructions.
The converter parameters can be set in " Free access "
status.
You can return to the operating status display by pressing
the <R> key (several times if necessary).
Operating display
Basic menu
Free access
<P>
<P> <R>
<R>