Siemens SIMOTRAS 6SG7050, Руководство по эксплуатации

Страница: 352 / 604

Parameter list 01.04
11-4
SIEMENS AG 6SG7000-0BA76
SIMOTRAS HD Operating Instructions
PNU Description Value range
[Unit] No. indices See
Change
11.1 Operating status display
r000 Operating status display
Status display, fault and alarm messages
Torque direction M0, MI or MII (=RUN)
- - No torque direction active
I Torque direction I active (MI)
I I Torque direction II active (MII)
o1
Waiting for operating enable (=READY)
o1.0 Brake release delay time running.
o1.1 Waiting for operating enable at terminal 38.
o1.2 Waiting for operating enable via binector (acc. to selection in
P661) or control word, bit 3 (acc. to selection in P648)
o1.3 Inching command cancellation delay time running.
o1.4 Reserved
o1.5 Reserved
o1.6 Reserved
o2 Wait for setpoint > P091.002
o2.0 If |n-set| (|K0193|) and |n-actual| (K0166) are less than
P091.002, the firing pulses are disabled and the drive goes into
state o2.0.
[SW 2.0 and later]
o3 Test phase
o3.0 Reserved
o3.1
Waiting for completion of line symmetry check.
o3.2 Waiting for a contactor in the motor circuit to pick up
o3.3 Waiting for "Main contactor checkback"
(control word 2 bit 31, see P691)
[SW 1.8 and later]
o4
Waiting for voltage (motor)
o4.0 Waiting for voltage at power terminals U1, V1, W1 (the
threshold set in parameters P351 and P353 must be exceeded,
see also P078.001)
NOTE
The system dwells in state o4 for no more than a time set in parameter
P089. The appropriate fault message is output if the corresponding
conditions are still not fulfilled at the end of this period.
o5 Reserved
o6
Wait status before the line contactor is closed
o6.0 Waiting for auxiliaries to be switched on (delay in P093)
o6.1 Waiting for a setpoint
≤
P091 to be applied to the ramp-function
generator input (K0193)
o7 Waiting for switch-on command (=READY TO SWITCH ON)
o7.0 Waiting for switch-on command via terminal 37.
o7.1 Waiting for switch-on command via binector (acc. to selection in
P654) or control word, bit 0 (acc. to selection in P648).
o7.2 Waiting for internal shutdown to be cancelled through input of
an external shutdown command
o7.3 Waiting for completion of "Restore factory settings" operation.
o7.4 Reserved
o7.5
Wait for completion of "Read in parameter set" operation.
o7.6 Wait for completion of "Load MLFB" operation.
(performed at factory)
o7.9 reserved for firmware download for optional supplementary
modules
[SW 2.0 and later]
Ind: None
Type: O2
P052 = 3