Siel Green Point 6 20KVA, Руководство пользователя

Страница: 52 / 61

IV319 Rev.00
Data 2010-06-22
Pag. 52 di 118
11. Setting by LCD Module
The output voltage rating and frequency rating and bypass state could
be set directly through LCD Display. The output voltage rating could be
set to 208V
*
, 220V, 230V and 240V. The output frequency rating could
be set to 50Hz and 60Hz. The bypass state could be set to enable and
disable. But all the settings could only be done when the UPS is in
Bypass or No Output mode.
In Bypass or No Output mode, press the Select button on the LCD panel
for more than one second, a flickering black line would be shown
XQGHUVLGH ³
50
´
on the screen. And if press the Select button
continuously again, the flickering black line would move to
³
60
´
, next to
around
³
208
´
,
³
220
´
,
³
230
´
,
³
240
´
,
³
ON
´
,
³
OFF
´
in turn. And if press the
Enter button for more than one second at this time, the flickering black
line would turn to flicker less and the output voltage rating or frequency
rating or bypass state setting would be modified to the selected value.
And if no any pressing on the Select or Enter button lasting for more
than ten seconds, the flickering black line would disappear, no setting
have be modified.
The only one voltage rating could be selected in
³
208
´
,
³
220
´
,
³
230
´
,
³
240
´
at any time, only one frequency rating could be selected in
³
50
´
,
³
60
´
at any time, and the output voltage and frequency would be
changed to the corresponding value after turning on the UPS by
pressing the ON button.
The UPS would turn into Bypass mode in several seconds after
³
ON
´
is
selected, and turn into No Output mode in several seconds after
³
OFF
´
is selected.
*
Note
: When the output voltage rating is set to 208V, the output power
must be derated to 90%.
Here is an example for changing the output voltage from 220 to 230
through the LCD panel.