Siel Green Point 6 20KVA, Руководство пользователя

Страница: 20 / 61

IV319 Rev.00
Data 2010-06-22
Pag. 20 di 118
5. Installation
5.1 Unpacking and Inspection
1) Unpack the packaging and check the package contents. The
shipping package contains:
Ⴠ A UPS
Ⴠ
A user manual
Ⴠ A SW CD+ RS232 communication cable
Ⴠ
A battery cable ( only on UPS 6 and 10K without battery )
2) Inspect the appearance of the UPS to see if there is any damage
during transportation. Do not turn on the unit and notify the carrier
and dealer immediately if there is any damage or lacking of some
parts.
5.2 Input and output power cords and protective earth
ground installation
1. Notes for installation
1) The UPS must be installed in a location with good ventilation,
far away from water, inflammable gas and corrosive agents.
2) Ensure the air vents on the front and rear of the UPS are not
blocked. Allow at least 0.20m of space on the front and rear of
the UPS.
3) Condensation to water drops may occur if the UPS is unpacked
in a very low temperature environment. In this case it is
necessary to wait until the UPS is fully dried inside out before
proceeding installation and use. Otherwise there are hazards of
electric shock.
The system may be installed and wired only by qualified
electricians in accordance with applicable safety regulations!