SICK ICR890, Руководство по эксплуатации

Страница: 69 / 128

Operating Instructions Chapter 5
ICR890
Electrical installation
8011325/0000/2006-10-24
©
SICK AG · Division Auto Ident · Germany · All rights reserved
69
5.4.6 Wiring the Ethernet interfaces GBIT 1 and GBIT 2
The two GBit Ethernet interfaces facilitate fast output of images to a special PC which is also
equipped with two GBit Ethernet interfaces.
Connecting the GBIT 1-ETHERNET and GBIT 2-ETHERNET interfaces
¾ Connect the ICD890 Camera directly to the Ethernet card of the PC (point-to-point
connection) using the crossover cables no. 6029775 (see
Tab. 5-10, page 63 ) .
- or -
Connect the ICD890 Camera to the GBit Ethernet network using the standardized data
cables (patch cables) no. 6029776.
5.4.7 Wiring the switching inputs IN 1 and IN 2
The reading pulse sensor is connected via the digital switching input IN 1 .
The incremental encoder is connected via the switching input IN 2 . Fig. 5-8 shows the wiring
of switching input IN 1 as an example. Tab. 5-15 contains ratings for both inputs.
Connecting the switching inputs IN 1 and IN 2
1. Connect the reading pulse sensor (photoelectric reflex switch) to switching input IN 1,
as shown in Fig. 5-8 .
2. Connect the incremental encoder to switching input IN 2, as shown in Fig. 5-8 .
3. For power supply via the ICD890 Camera, additionally establish connections between
SGND and GND in the connector of the connection cable.
Abb. 5-8: Wiring of the switching inputs IN 1 and IN 2
PNP sensor Switch
ICR890 System
V
S
= +24 V DC
*) V
imax
= 28 V!
Vo
Switching
behaviour IN 1: Power fed to the input opens the reading gate of the ICD890 Camera.
(Default setting: Not inverted (active high); debouncing: 10 ms; pulse start
delay: 0 ms, pulse end: 0 ms)
Features – Optodecoupled, reverse polarity protected
– Can be wired with the PNP output of a sensor
Electrical values Low:
–1 V
≤
V
i
≤
+1 V
–0.3 mA
≤
I
i
≤
+0.3 mA
High:
+8 V
≤
|V
i
|
≤
+28 V
+1.4 mA
≤
|I
i
|
≤
+18 mA
Tab. 5-15: Ratings of the switching inputs IN1 and IN 2