Operating Instructions
Chapter
1
ICR890
Notes on this document
8011325/0000/2006-10-24
©
SICK AG · Division Auto Ident · Germany · All rights reserved
15
1
Notes on this document
1.1
Purpose
This document provides instructions for
technical staff
on the installation and operation of
the following ICR890 System models:
•
The ICR890 System equipped with focus control, CCD sensor 8,192 pixels, standard
lens (focal distance 135 mm (5.32 in))
This document contains the following information:
•
Installation and electrical installation
•
Startup
•
Operation and configuration
•
Maintenance
•
Troubleshooting
•
Replacing system components
A step-by-step approach is taken for all tasks.
1.2
Target audience
The target audience of this document is persons assigned the following tasks:
1.3
Information content
This document contains all the required information for installation, electrical installation
and operation of the ICR890 System at the installation location. The
factory configuration
(default setting) of the ICR890 System as a
stand-alone device
is optimized to a
single-side reading
(from above or from the side).
Configuration of the ICR890 System for the
application-specific reading conditions
and
operation is carried out via the SOPAS-ET Configuration Software at a Windows
TM-
PC. The
SOPAS-ET Configuration Software contains an online help system to facilitate configuration.
Electrical installation of the MSC800 controller for a
ICR890 System
as
stand-alone device
and its configuration is detailed in the
MSC800 Operating Instructions
(no. 8011540).
These instructions also described use of the MSC800 as a controller for a
multi-side
reading
.
Note
Further information on High End CCD Camera Systems, Volume Measurement Systems and
Bar Code Scanners is available from SICK AG, Auto Ident division.
On the Internet at
www.sick.com
.
Tasks
Target audience
Installation, electrical installation,
maintenance, replacing system
components
Qualified staff, e. g. service technicians and factory
electricians
Startup, operation and configuration
Qualified staff, e. g. technicians and engineers
Operation of the conveyor system
Qualified staff for startup and operation of the conveyor
system
Tab. 1-1: Target audience
