SICK CLV 45 Series, Руководство по эксплуатации

Страница: 71 / 174

Operating Instructions Chapter 6
CLV 45x Bar Code Scanner
Operation
8 009 139/K949/06-06-2002 © SICK AG · Division Auto Ident · Germany · All rights reserved
6-19
Line scanner with oscillating mirror:
In reading mode the CLV deflects the scan line in the default setting with a frequency of 1 Hz
around the position CW = 50 at a maximum angle of
±
20
°
. 50 CW corresponds to a light
emission under 105
°
.
Displaying the read result in the terminal emulator
1. Click on in the toolbar.
The terminal emulator dialog box is opened.
2. Click on the R
EADING MODE
radio button under D
EVICE MODE
.
3. Present the bar code pattern from Fig. 6-1, Page 6-3 to the CLV 450 respectively the
bar code pattern from Fig. 6-2, Page 6-4 to the CLV 451 and activate the reading pulse.
The "Laser On" LED lights up. The scan line then appears. Also refer to Chapter 6.3.1
Starting up the line scanner/line scanner with oscillating mirror with the factory default
setting, Page 6-3 .
4. Terminate reading pulse.
The CLV outputs an acoustic signal via the beeper to indicate that the reading result is
displayed in the window of the terminal emulator. The "Result" LED lights up for a
duration of 100 ms (default setting).
Fig. 6-7 shows two examples of the output of a read result: “Good Read“ and “No Read“.
The read result comprises the data contents of the bar code(s) and the reading diagnosis
data. Fig. 6-8 explains the structure and function of the reading diagnosis data for Good
Read, and Fig. 6-9 for No Read.
Note The CLV only outputs several bar codes in the read result if the parameterized minimum and
maximum number of bar codes is >1, and several bar codes have been presented. The
number of bar codes to be read/output for each read port can be selected in the C
ODE CON
-
FIGURATION
tab card in the N
UMBER OF CODES
section.
Fig. 6-7: CLV-Setup: Displaying the read result of the terminal interface in the terminal emulator