- 14 -
Step 4
Install Internal Peripherals in System Case
Before you install and connect the mainboard into your system case, we
recommend that you first assemble all the internal peripheral devices into the
computer housing, including but not limited to the hard disk drive (IDE/
HDD), floppy disk drive (FDD), CD-ROM drive, and ATX power supply unit.
This will greatly facilitate in making the connections to the mainboard de-
scribed below.
To install IDE & FDD drives, follow this procedure:
1. Set the required jumpers on each device according to the instructions
provided by the manufacturer. (IDE devices, HDD, and CD-ROM, have
to set jumpers to Master or Slave mode depending on whether you install
more than one device of each kind.)
2. Connect IDE cable and FDD cable on the back-panel of the internal
peripheral devices to the corresponding headers on board. Note that
the cable should be oriented with its colored stripe (usually in red or
magenta) connected to pin#1 both on the mainboard IDE or FDD
connector and on the device as well.
3. Connect an available power cable from your system power supply unit
to the back-panel of each peripheral device. Note that the power cable
is directional and cannot fit in if not properly positioned.
Содержание MV43VN
Страница 1: ...MV43VN Pentium 4 Processor Based DDR SDR MAIN BOARD User s Manual ...
Страница 23: ... 19 5 Internal speaker header SPK1 Step 9 Connect the Power Supply 1 System power connectors ATX2 ATX1 SPK1 ...
Страница 24: ... 20 Step 10 Install Add on Cards in Expansion Slots 1 Accelerated Graphics Port AGP Card 2 PCI Card 3 CNR Card ...