Shuttle MV43VN, Руководство пользователя

Страница: 67 / 79

- 63 -
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC). If you
install add-on FDC or the system has no floppy drive, select Disabled.
Ø The choice: Disabled or Enabled.
Onboard Serial Port1
This option is used to assign the I/O address and address and interrupt
re-quest (IRQ) for onboard serial port 1 (COM1).
Ø The choice: Disabled, 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3,
or Auto.
Onboard Serial Port2
This option is used to assign the I/O address and interrupt request (IRQ)
for onboard serial port 2 (COM2).
Ø
The choice: Disabled, 378/IRQ7, 278/IRQ5, or 3BC/IRQ7.
UART Mode Select
This field is available if the Onboard Serial Port 2 field is set to any option
but Disabled. UART Mode Select enables you to select the infrared
communica-tion protocol-Normal (default), IrDA, or ASKIR. IrDA is an
infrared communication protocol with a maximum baud rate up to 115.2K
bps. ASKIR is Sharp's infrared communication protocol with a maximum
baud rate up to 57.6K bps.
Ø The choice: Normal, IrDA, ASKIR or SCR.
UR2 Duplex Mode
This field is available when UART 2 Mode is set to either ASKIR or IrDA.
This item enables you to determine the infrared function of the onboard
infrared chip. The options are Full and Half (default).
Ø The choice: Full or Half.
Onboard Parallel Port
Allows you to determine an I/O address and interrupt request (IRQ) for
the onboard parallel port.
Ø The choice: Disabled, 378/IRQ7, 278/IRQ5, or 3BC/IRQ7.
Parallel Port Mode
Enables you to set the data transfer protocol for your parallel port. There
are four options: SPP (Standard Parallel Port), EPP (Enhanced Parallel Port),
ECP (Extended Capabilities Port) and ECP+EPP.