Shindaiwa Limited
POWERCENTER 15
Four Ashes, Wolverhampton, UK
PC15-OM-Vs: 1
T: +44 (0)1902 791855
CLOSE
OPEN
Plug (R1")
Bolt (M6)
Guard
4 bolts
(6) Changing the Cooling Water
Change
Every 2,000 hours or 2 years
Cooling Water Total Capacity: Approximately 4 L
(Including the sub tank capacity of approx. 0.6 L
1)
Open the top plate.
2)
Remove the radiator cap.
3)
Remove the water drain plug.
4)
Drain the cooling water and tighten the
water drain plug.
5)
Change the cooling water in the sub tank.
6)
Pour cooling water into the water inlet until it
reaches the mouth of the port.
7)
Tighten the radiator cap.
8)
Close the top plate
<Note>
Replace the packing with a new part each time
you change the cooling water.
Packing part no.: 6C090-58961 (Kubota part
no.)
Operate the engine for a short period and check
that there is no cooling water leakage. Stop the
engine when completed.
(7) Drain the Spill Containment
Drain
Pre-operation
1)
Set a large pans or bucket under the drain port of the spill containment to catch the
liquid.
2)
Remove the guard by loosening bolts.
3)
Remove the plug (R 1") of the spill containment drain valve and turn the plug counter
clock wise.
4)
Tighten the (R 1") plug with thread seal tape by 19.6N-m.(by adjustable wrench)
5)
Reinstall the guard.
<Note>
It is possible that there is a fuel or oil leak if the drained fluid contains oily components. If
this occurs, check for leakage locations. Although the fluids that can leak internally
consist of oil, fuel, cooling water and battery fluid, the spill containment does not have a
function that can separate rainwater that has leaked into the equipment from these
internally leaked fluids. Properly dispose of liquid drained from the spill containment in a
manner according to the applicable laws and regulations.
Cup
Radiator Cap
Water
Inlet
Top Plate
Water Drain Plug
Sub
Tank
給水口
-39-
