Shibaura ST329, Руководство оператора

Страница: 58 / 72

LUBRICATION AND MAINTENANCE
51
HANDBRAKE ADJUSTMENT
Adjustment of the handbrake should be carried
out after the foot brakes have been adjusted.
Broke the front wheels, jack up the rear of the
tractor and support the rear wheels just clear of
the ground. Unlatch the brake pedals.
Remove the cover of the handbrake mechanism
as shown in Figure
79 , to gain access to the ca-
ble adjusters. Apply the handbrake so that the
4th..notch of the sector is engaged. Tighten the
self locking nuts, on the operating cables until
both wheels start to lock. Release the handbrake
and ensure that both wheels are free to rotate.
Apply the hand brake to ensure that the system
operates freely. Refit the waterproof cover over
the handbrake mechanism.
Figure 79 - Handbrake Adjustment
Road test, using the handbrake to stop the tractor.
The tractor should stop in a straight line if the ca-
bles have been correctly adjusted.
CLUTCH PEDAL ADJUSTMENT
To obtain maximum clutch life, it is essential that
the clutch pedal free travel be checked every 50
hours so as to maintain free travel at 20-30 mm,
Figure
80 .
1. Remove the cotter pin and clevis pin.
2. Turn the clevis to increase or decrease pedal
travel as required.
Figure 80 - Clutch Pedal Free Travel Adjustment
FOUR-WHEEL DRIVE
FRONT AXLE DIFFERENTIAL CASE
AND FINAL REDUCTION GEAR CASES
Checking Oil Level
： ： ： ：
Check the oil level every 50
hours.
1. With the tractor standing level and the engine off,
check the oil level with the dipstick, Figure 81 .
2. The oil is at the correct level when the oil level is
between the mark and lower end of the dipstick.
If low, add new oil of the type specified, page
35 ,
through the combined dipstick/ filler plug. Do not
fill beyond the mark on the stick, as the front
axle case will be overfilled.
3. Install the dipstick/filler plug.