Shibaura ST329, Руководство оператора

Страница: 14 / 72

CONTROLS, INSTRUMENTS AND OPERATIONS
12
INSTRUMENT PANEL
Instrument Panel
①
Engine Oil Pressure Warning Light - Illumi-
nates with the key switch in the “ON” or “HEAT”
positions and remains lit for a short period of
time after the engine is started. The light indi-
cates oil pressure only and goes out when suf-
ficient oil pressure is present at the oil sender.
If the bulb becomes lit during operation, stop
the tractor engine immediately and investigate
the cause.
②
Cold Starting Indicator Light - Illuminates
when the key switch is turned to the “HEAT”
position. It remains lit for approximately 5 sec-
onds when the key is held in position, during
which time the glow plugs are heating the
pre-combustion chambers.
③
Battery Charge Warning Light - Illuminates
when the key switch is in the “ON” or “HEAT”
positions and goes out when engine is started.
If this bulb becomes lit during operation, it indi-
cates the charging system is not operating
normally. As the battery can become fully dis-
charged under these conditions, the problem
should be investigated as soon as possible.
④
Proof Meter - Records the hours and portions
of hours that your tractor has been operated
based on an average engine speed of 1883
RPM. Use the proof meter as a guide to deter-
mine hourly service maintenance intervals.
⑤
Tachometer- Registers engine RPM (Revolu-
tions Per Minute). The gauge is marked in in-
crements of 100 and will return to zero when
the engine is not running.
⑥
High Beam Indicator - Illuminates when the
head-lights are switched to main beam.
⑦
Parking Brake Light - Illuminates if the park-
ing brake is engaged when the key switch is
turned from “OFF” position.
⑧
Fuel Gauge - Indicates the amount of diesel
fuel when the key switch is in the “ON” or
“HEAT” positions. It will register empty with the
key switch in the “STOP” position.
⑨
Turn Indicator Warning Lights - Flash in un-
ion with the turn signal warning light when the
lever is moved to the right-hand or left-hand.
⑩
Temperature gauge - Indicates coolant tem-
perature. It is activated when the key switch is
turned to the “ON” or “HEAT” positions. The
gauge will register cold with the key switch in
the “STOP” position. If the needle registers in
the green range, this indicates a normal oper-
ating temperature. If the needle moves to the
red portion of the gauge, this indicates an
overheated condition. Stop the tractor engine
immediately and investigate the cause.
⑪
Rear PTO Speed - Determined by the portion
of the needle on the tachometer. The tachome-
ter is marked to indicate 540 PTO RPM. Engine
RPM should remain close to this mark while
using the rear PTO; running the engine faster
than this results in a dangerous over speed
condition.
⑫
Hazard Indicator Warning Lights - Flash in
union with the hazard warning light when the
lever is moved clockwise.