Shibaura ST329, Руководство оператора

Страница: 26 / 72

CONTROLS, INSTRUMENTS AND OPERATIONS
24
HOOD LATCH
1. To raise the hood, move the latch lever
①
, to
the right, or the hood may be raised up sligtly.
And then move the safety catch
②
to the
left-hand / upward with inserting your hand be-
low the hood. Figure
30 . Lift the hood to its fully
raised position. A support link, Figure 31 , will
automatically hold the hood in the fully raised
position.
2. To lower the hood, lift up on the hood slightly
and pull the support link towards you, so that the
support pin is no longer in the catch position.
Lower the hood until it is retained by the latch
mechanism.
Figure 30 - Hood Latch
Figure 31 - Support Link, Hood
IMPORTANT : Do not attempt to lower the hood
without moving the support link. Attempting to force
the hood down can result in bending or breaking of
the hood and support linkage.
NOTE
： ： ： ：
Keep the latch mechanism free of the dirt
and the debris so that the latch assembly will oper-
ate properly.
THREE POINT LINKAGE
The tractor’s standard three-point linkage is used to
attach mounted equipment to the rear of the tractor.
This can be ground driven, PTO operated or trailed.
The three “points” of the linkage are the Category
1 ball ends on the two lower lift arms and the top
link.
Figure 32 - Three-Point Linkage
Linkage Adjustment
The three-point linkage has adjustable stabilizers to
control lateral movement of the lift arm. Loosen the
lock nut and turn the adjuster
②
, to shorten or
lengthen the stabilizer. Re-tighten the lock nut.
The height of the right-hand lift arm can be ad-
justed by loosening the lock nut and turning the
threaded adjuster
①
on the lift rod.
To adjust the height of the left-hand lift arm
re-position the attaching bolt
③
, in one of the al-
ternative holes in the lift rod.
Figure 33 - Linkage Adjustment, Three-Point