Shibaura ST329, Руководство оператора

Страница: 16 / 72

CONTROLS, INSTRUMENTS AND OPERATIONS
14
is available as a dealer installed option.
STARTING THE TRACTOR WITH
JUMPER CABLES
WARNING
： ： ： ：
Start engine only from
the operator’s seat.
If it is necessary to use jumper cables to start the
tractor, follow the instructions below.
1. Shield eyes.
2. Connect one end of the jumper cable to the
tractor battery positive (
＋
) terminal and the oth-
er to the auxiliary battery positive (
＋
) terminal.
Connect one end of the other cable first to the
auxiliary battery negative (
－
) terminal, and the
other end to the tractor starter ground terminal.
Follow the starting procedures indicated previ-
ously above.
Idle the engine and turn on all electrical equipment
(lights, etc.), then disconnect the cables in reverse
order of the connecting procedure above. This will
help protect the
alternator from damage due to
extreme load changes.
WARNING
： ： ： ：
Batteries contain sulfuric
acid and produce explosive gases.
Follow the instructions below to pre-
vent personal injury.
Wear eye and skin protection.
Keep sparks and flame away.
Always have adequate ventilation while charg-
ing or using the battery.
Follow the battery manufacturer’s instructions
shown on the battery.
STOPPING THE ENGINE
Push the hand throttle fully forward and turn the
key switch, Figure 9 , to the “OFF” position to stop
the engine.
IMPORTANT
： ： ： ：
Failure to turn the key switch to the
“OFF” position after the engine has stopped will al-
low the warning lights to remain on, causing the
battery to discharge.
BREAK-IN PROCEDURES
Your SHIBAURA Tractor will provide long and
dependable service if given proper care during the
50 hour break-in period. During the first 50 hours
of operation :
1. Avoid “lugging” the engine. Operating in too
high a gear under heavy load may cause engine
“lugging”, which is indicated when the engine
will not respond to a throttle increase.
2. Use the lower gear ratios when pulling heavy
loads and avoid continuous operation at con-
stant engine speeds. You will save fuel and
minimize engine wear by selecting the correct
gear ratio for a particular operation. Operating
the tractor in low gear with a light load and high
engine speed will waste fuel.
3. Avoid prolonged operation at either high or low
engine speeds without a load on the engine.
4. Check the instruments frequently and keep the
radiator and oil reservoirs filled to their recom-
mended levels. Daily checks include :
Engine oil level
Radiator coolant
Air cleaner
5. After the first 50 hours of use, be sure to per-
form the maintenance chart ,on Page 32 .
WARNING
： ： ： ：
Never attempt to start the
engine while standing beside the trac-
tor
－
always sit in the seat when start-
ing the engine.