Shibaura ST329, Руководство оператора

Страница: 42 / 72

LUBRICATION AND MAINTENANCE
35
erate properly.
LUBRICANTS
Type of lubricant to use,
Transmission, Rear Axle, Final
Reduction, and Hydraulic System
･･････
SAE 80
Hydraulic Transmission Oil
･････････
ISO VG 46
Front Axle, Final Reduction Oil
･･････････
SAE 80
Engine Crankcase
･･････････
Service Grade CD
SAE 10W30, for year around use
or
SAE 20W for use -5
℃－
25
℃
SAE 30 for use 10
℃－
35
℃
All Lubrication Fittings
･････
NLG 1 GRADE 2 EP
GREASE WITH LTIUM
SOAP
NOTE
：
： ：
：
Use the following chart to determine which
SAE Grade engine oil to use :
In areas where prolonged periods of extreme tem-
peratures are encountered, local lubricant practices
are acceptable, such as the use of SAE 5W (CC) in
extremely cold temperatures or the use of SAE 40
(CD) or SAE 50 (CD) in extremely high tempera-
tures.
IMPORTANT
： ： ： ：
Engine crankcase oil drain intervals
should be adjusted downward when diesel fuel
sulfur content is over 0.5%.
Consult your dealer for details of Engine Crank
case Oil usage.
FUEL AND LUBRICANT SERVICE
PROCEDURES
ENGINE
Checking Oil Level
： ： ： ：
Check the engine oil level
daily or every 10 hours.
1. With the tractor standing level, and after the
engine has been stopped for a period of time,
check the oil level with the dipstick, Figure
49 .
Figure 49 - Engine Oil Level Dipstick and Oil Filter
2. If the oil level is low, remove the filler cap,
Figure 50 , and add oil to the engine through the
filler hole to bring the oil level between the
marks on the dipstick. Be careful not to overfill.
3. Install the oil filler cap.
Changing Oil and Filter
： ： ： ：
Change the engine oil
every 100 hours and the engine oil filter every
200 hours.