CONTROLS, INSTRUMENTS AND OPERATIONS
23
PTO speeds relative to engine speeds are
shown in the following tables
:
PTO Type
Ratio
PTO
Speed
(rpm)
Engine
Speed
(rpm)
Single-speed
(Manual trans.)
(HST trans)
-
-
540
540
2455
2500
2-speed
(Manual trans.)
1
2
540
750
2485
2350
Mid-mounted
(Manual trans.)
(HST trans)
-
-
2000
2000
2377
2420
WARNING
:
:
:
:
Rear PTO speeds in ex-
cess of 630 PTO rpm may damage
equipment that is designed for 540 rpm
operation and could result in personal
injury to the operator or bystanders.
7. Disengage the PTO with the PTO control lever
with mounted equipment in the fully raised posi-
tion.
8. Disconnect the P.T.O.-driven shaft at the tractor
PTO shaft before traveling on highways or for
any great distance.
9. Reinstall the PTO shaft cap when the
PTO-driven equipment is disconnected from the
tractor or when the PTO is not being used.
WARNING
:
:
:
:
To avoid inadvertent
movement of PTO implement, disen-
gage PTO after each use.
TOWING THE TRACTOR
To tow your tractor, place the transmission gear-
shift levers in neutral. Do not exceed 13 km/h. Do
not tow your tractor to start it.
If the tractor is to be moved any great distance, use
a solid tow bar and pull the tractor at a speed not to
exceed 13 km/h.
WARNING
:
:
:
:
For safety reasons, towing
the tractor on the highway is not rec-
ommended. Also, for safety reasons,
never attempt to start the engine by
towing.
EXTENSION / CLEVIS DRAWBAR
Your tractor is equipped with a extension/clevis
type drawbar, shown in Figure
29
for towing
equipment behind the tractor.
This drawbar may be extended for sliding it rear-
ward, 145 mm.
IMPORTANT :
When transporting equipment on
highways, a safety chain with tensile strength equal
to the gross weight of the implement should be in-
stalled between the tractor and implement hitch.
WARNING
:
:
:
:
Pull only from the drawbar,
always use the drawbar or lower links
in the lowered position when perform-
ing pull-type work..
Figure 29 - Extension / Clevis Drawbar
Содержание ST329
