shelolab SM10HP-2, Инструкция по установке и эксплуатации

Страница: 25 / 44

25 | P a g e
OPERATION (CONTINUED)
S
ET THE
T
EMPERATURE
S
ET
P
OINT
Note: Set the oven temperature to 200°C for the First Use Burn-In Process.
There are three ways to set the oven chamber temperature. You may use any of these for the
Burn-In procedure.

Program and launch a heating profile . A profile can run the oven at a single steady state
temperature, or include heat soaks at multiple set points, as well as the ramp up and ramp
down times needed to heat up to or cool down to these temperatures.
o
Please see pages 5
– 15 of the
Operation and Programming Guide
– JUMO
dTRON that came with this oven for how to program and launch or abort a heating
profile.

Place the oven in its single set point function mode . After placing the unit in the single
set point mode, use the arrow buttons to adjust the set point to your application
temperature set point. The oven will ramp up to this temperature and run at it indefinitely.
o
Please see pages 16
– 17 of the
Operation and Programming Guide
– JUMO
dTRON for how to place the unit in single set point mode.

Unlock and adjust the temperature set point . This is the simplest option when
performing the First Use Burn-In, and leaves the oven controller in its heating profile
function mode. See below.
Unlock and Adjust the Heating Set Point
1. Unlock the Set Point
a. Press and hold the down arrow button until the green set point
(bottom) begins to blink.
Home Page
2. Adjust the blinking set point to your application set point (200°C for the
First Use Burn-In).
a. Use the Up and Down arrow keys.
Note : After 3 seconds or more of no activity, the set point will lock, cease blinking,
and store the last displayed value as the new set point.
New Set Point
3. After adjusting to the set point, wait 3 seconds.
a. The controller will save and lock the new set point value
b. Allow the oven time to heat to the set point. The oven will run
indefinitely at this temperature.
Heating