![shelolab SM10HP-2 Скачать руководство пользователя страница 24](http://html1.mh-extra.com/html/shelolab/sm10hp-2/sm10hp-2_installation-and-operation-manual_1255392024.webp)
24 |
P a g e
OPERATION (CONTINUED)
P
REPARING THE
O
VEN FOR
U
SE
Preform the following steps to prepare the oven for use after installing it in a new workspace environment.
The First Use Burn-In procedure is intended to remove any traces of protective oil coatings from the oven
elements and prevent smoking during your first application or heating profile run above 150°C. This also
removes any residual cleaning agents left on the oven chamber surfaces. The procedure only needs to
be performed once, after receiving the oven from the factory.
1. Open the intake and the exhaust vents of the First Use Burn-in Procedure.
2. Attach any ducting to the exhaust vent at this time.
3. Place the Power Switch to the ON position.
a. The controller display will illuminate and load its
homepage.
4. Set up the oven for use by carrying out the following
procedures in order, found in the Operation section:
Prepare for First Use Burn-In
, page 24
Set the Temperature Set Point
for the burn-in, page 25
First Use Burn-In
,
page
26
Optional:
Temperature Verification
, page 28
Set the Over Temperature Limit
for you application temperature, page 30
P
REPARE FOR
F
IRST
U
SE
B
URN
-I
N
If the oven is being run for the first time out of the box, perform the steps below followed by the
Burn-In procedure to burn off the protective oil coating from the oven heating element.
1. If not already set to its maximum position, turn the OTL control dial all the way to the
right (clockwise) so that it does not interfere with the Burn-In process.
a. The OTL should come from the factory set to its maximum position.
2. Positively vent the oven exhaust outside of its workspace environment during the
Burn-In Procedure. The procedure will produce light smoking.
a. The smoke should be non-toxic, but may be noxious.
3. Use the Set the Temperature Set Point procedure on the next page to set the oven to
run at 200C°.
Controller Display
Homepage
Chamber Temp in Red
Current Set Point in
Green
Содержание SM10HP-2
