Sesamo Puma Millenium, Инструкция по установке

Страница: 10 / 28

10
Installation Instruction
PIUMA MILLENNIUM
Installation of the guide and rigid pull arm
Insert the threaded hexagon in the upper part of the hexagonal hole of the
gearmotor (Fig.12 part.A). Assemble the rigid pull arm (Fig.12 part.B) to the
upper hexagon with the flathead screw M6x70 supplied (Fig.12 part.C) after
having interposed the washers Ø6,4x12 (Fig.12 part.D) as shown in the figure
12.
Before tightening the flathead screw, check carefully that the distance bet-
ween the guide and the rigid arm is about 13 mm (Fig.13).
It is possible to achieve the right distance by varying the number of washers
placed between the hexagons previously assembled (max. 8 washers) (Fig.12
part D). Once the required distance is obtained, tighten the flathead screw
well.
Fig.12
Fig.13
A
B
C
D
Fig.15
Installation of the articulated push arm
Insert the threaded hexagon in the upper part of the hexagonal hole of the
gearmotor (Fig.14 part.A). Assemble the articulated push arm (Fig.14 part.B)
to the upper hexagon with the flathead screw M6x70 supplied (Fig.14 part.C)
after having interposed the washers Ø6,4x12 (Fig.14 part.D) as shown in the
figure 14.
Before tightly shutting the flathead screw, carefully check that the upper part
of the articulated arm easily rotates under the door frame and that the obtai-
nable distance, by adjusting the washers (max. n. 8) (Fig.14 part.D) between
the hexagons, ranges between 12 and 24 millimeters measured between the
cover of the automatism and the upper part of the articulated arm (Fig.9)
Make holes in the frame of the diameters shown in fig.9 and fix to the latter
the door attachment of the articulated arm with the appropriate screws. Close
the door, loosen the fixing screws situated in the adjusting slots by lengthe-
ning the extendible part of the arm, adjust the geometry of the same so as to
enable its correct operation over the entire arc of use. Fix the adjustment by
tightening the setscrews tightly in the extendible part of the arm so using the
holes furthest apart.
Fig.14
A
B
C
D