CR/41 CONTROL UNIT INSTALLATION
Position the equipment in the vicinity of the gate, to minimise the length of cables for connection to the rest of the
system.
For further protection against atmospheric agents, position the control unit under a canopy or for improved
protection in an enclosure also fitted with two lateral walls. The equipment should also be installed at a height of at
least 1.5 meters, to keep it out of the reach of children.
CONTROL UNIT POSITIONING
The control unit leaves the factory with the cover positioned for opening from the left-hand side.
To invert the cover opening side, proceed as follows:
WARNING: This operation must be performed before
fixing the enclosure to the wall.
Insert a slotted screwdriver in the hinge fixture slot at the rear
of the base and lever the hinge connection tooth while pulling
the cover up to remove. (see Fig. 1)
Fig.1
Insert a slotted screwdriver in the hinge fixture slot on the front
of the cover and lever off the hinge connection tooth while
pulling up the hinge. (see Fig. 2)
Fig.2
Refit the hinges on the right side of the base, inserting
them in the relative seats with the connection teeth
facing the interior of the enclosure, until they click into
place (see Fig. 3).
Fig.3
SETTING THE COVER FOR OPENING TO RIGHT
!
Page 7/18
SIN
CE
1
96
5
K
IT
/3
0
-3
9
F
I
E
