DA
L
19
65
Pag. 4/18
PILLAR
HINGE
GATE
A
6
0
m
m
6
0
m
m
280 mm
860 mm (MT/30/2)
660 mm (MT/38/1)
1
1
5
m
m
8
0
m
m
Attenzione!
Limite di corsa. Non superare
Caution!
Limit of stroke. Do not exceed
Attenzione!
Limite di corsa. Non superare
Caution!
Limit of stroke. Do not exceed
Fig. 3
950 mm (MT/30/2)
750 mm (MT/38/1)
Fig. 2
Fig. 1
BEFORE INSTALLING THE MOTORS
1- Ensure perfect right angles of the gate hinges to
enable totally smooth and balanced swing gate
movement. Otherwise the motor may be damaged
when subject to much higher levels of resistance with
respect to those specified for intended use.
2- In the maximum gate opening and closing positions,
check that two sturdy travel stops are anchored to the
ground to block the gate leafs at the end of travel Fig.
2 -. Otherwise install as necessary.
3- Ensure that the distance between the gate hinge and
post surface, marked A in fig. 2, is:
- less than 130 mm for an opening angle of 90°
- less than 110 mm for an opening angle of 100°
- less than 80 mm for an opening angle of 110°
4- The motor is supplied with the mobile pin (PM) - Fig. 3
- in the correct position for installation. However,
ensure that the distance of the mobile pin from the rear
connection point is:
- 860 mm for motors MT/30/2.
- 660 mm for motors MT/38/1.
Any distance greater than the specified value may
cause shutdown of the motor shortly before the gate
reaches the closing end stop; shorter distances will
cause a smaller opening angle than that required.
WARNING:
NEVER EXCEED THE PIN
STROKE LIMITS AS
INDICATED ON THE MOTOR
Attenzione!
Limite di corsa. Non superare
Caution!
Limit of stroke. Do not exceed
OPENING
AND CLOSING
END STOP
LATERAL VIEW
VIEW FROM BELOW
K
IT
/3
0
-3
9
F
I
E
