LISST-
HOLO User’s Guide
43
The
‘Samples’ setting will stop data collection when the specified number of
samples has been collected.
After making changes to the settings press on the Apply button to save the
settings and refresh the page.
All four sets of start and stop conditions can be programmed.
Selecting the start/stop program using the PC
When the four start and stop conditions have been programmed, you can select
which program you want to use by selecting the appropriate radio button and
clicking apply.
5.3 Preparing for Deployment
Now that the sampling parameters are configured we can prepare the
instrument for deployment and start the sampling. The procedure is slightly
different, depending on whether the LISST-HOLO is deployed with or without
the External Memory Module (EMM). These two scenarios are described below.
with the EMM installed
The first step is to put the instrument into low power sleep mode so that we can
disconnect the Ethernet cable and install the EMM.
!
In order for the EMM to be recognized it must be in place before power is
applied OR while the instrument is in sleep mode.
Navigate to the Tools page and click the Sleep button at the Sleep or reboot
line.
This will shut down the primary data logger and the green LED on the endcap
should be blinking every 30 seconds instead of every few seconds.
Disconnect the Ethernet cable and plug in the External Memory Module using
the special threaded locking part to hold it in place.
Proceed with section 5.4.
without the EMM installed
It is NOT necessary to install the EMM in order to sample with the LISST-
HOLO. In this case the holograms will be stored to the internal drive of the
LISST-HOLO.
If the EMM is not used, the 8-pin dummy MUST be installed onto the 8-pin
connector. Failure to do so may short circuit the instrument and damages the
electronics.
Unplug the yellow Ethernet cable and install the 8-pin connector.
Proceed with section 5.4.
Содержание LISST-HOLO
