Sequoia LISST-HOLO, Руководство пользователя

Страница: 17 / 73

LISST-
HOLO User’s Guide
17
When you are connected to the router, plug in the power to the DB-9 connector.
It is not necessary to have the DB-9 connector attached to the PC.
IMPORTANT: MAKE SURE THAT THE POWER CABLE IS FIRMLY SEATED IN THE
CONNECTOR.
EVEN MORE IMPORTANT: NEVER UNPLUG THE POWER TO THE LISST-HOLO
WHILE IT IS RUNNING. ALWAYS PUT THE INSTRUMENT TO SLEEP BEFORE
UNPLUGGING POWER.
Make sure that the magnetic switch on the connector endcap is in ‘0’ position (off). The
magnetic switch does not need to be in the
‘1’ position to communicate with the LISST-
HOLO.
Plug in the LISST-HOLO power supply in order to apply power to the LISST-HOLO.
The LISST-HOLO will boot up. The endcap LED will flash yellow for approximately 30
seconds. When it is ready, the LED will blink green every 5 seconds. See section 10 for
more information about the LED colors and status light indicators.
NOTE: The LISST-HOLO has no internal power. Whenever power is applied to the
instrument, the internal processor is powered on and initiates its boot-up procedure.
The LISST-HOLO cannot boot up any faster than 30 seconds.
3.3 Take a hologram If you have followed the instructions in section 3.2 the LISST-HOLO is now powered up
and connected to your PC. It is time to take a hologram!
Open up a web-browser on your computer, e.g. Firefox, Google Chrome or Internet
Explorer.
To connect to the LISST-HOLO, use URL
http://192.168.0.150/
Note: The IP address of the instrument can be changed, and in most cases it must be